3 of 11
INSTALLATION OVERVIEW
1. During the rough-in phase install the necessary power and cabling for the TS2 keypads. See
connection diagrams below and refer to ELAN documentation for keypad power requirements.
2. If using the TS2 keypads with Legacy controllers (HomeBricks or MultiBricks) you will also need to
run a Cat5 wire from the location of the VIA!Net port on the Controller or SC1 back to the Network
Assembly of the OneHome system to provide the serial connection needed to communicate. Refer to
the RS-232 Connection Options Integration Note for other serial connection options.
3. Install the keypads and other home media and control components.
4. Connect the OneHome system to the VIA!Net electrically. See the connection diagram for more
information.
5. Configure the OneHome system for the keypads and confirm communication between the keypads
and the controller.
6. Configure and test the keypads for proper operation, See HomeLogic configuration details below.
INITIAL SC1 CONFIGURATION NOTES
NOTE: The ELAN SC1 Serial Controller device is used to provide an RS-232 to VIA!Net bridge and is
required when using TS2 keypads with Legacy HomeBrick and MultiBrick controllers.
The SC1 must be updated using the following procedure for use in a g! system. If you are unsure
of the version of the SC1 use the following procedure to update it to the minimum version. This
procedure requires a PC with a USB port, a USB “A” to USB “Mini-B” cable, the SC1, the ELAN Firmware
Update Utility included with g!ConnectPro, and the ELAN Common Resources Library available from the
ELAN dealer website which includes the required firmware files.
SC1 Firmware update procedure:
1. Verify that you have g!ConnectPro version 5.2 Build 583 or newer.
2. Run the Firmware Updater: Click Start/All Programs/ELAN Home Systems/ Tools/Firmware Updater.
3. Using the USB-USB-mini cable connect the SC1 to the PC. Remove all other connections to the
SC1, it will be powered by the USB connection during the update.
Note: if this is the first time an ELAN USB device is connected to your PC you may see a pop-up
message as the USB device driver installation is completed which may require a reboot of your
system.
4. From the Device drop down menu select SC1. The firmware files window will populate with the
available firmware files.
5. Click the Transfer button. The Status window will indicate the progress as the firmware is
downloaded to the device.
6. Wait for the download to complete then click done to close the update utility. Disconnect the SC1
from the PC.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce